Plug in Capacitive touch enclosure kit

A 3D printed enclosure for the AAIO V1 board with provisions for a speaker and capacitive touch contacts at the corner case screws. I partnered up with Adam K6ARK to offer his tiny capacitive touch board with this enclosure kit. 

NOTE: Enclosure does not have previsions for microphone or PTT. Plug-in external hand mic for SSB work. If PTT switch is installed it will need to be removed. 

Kit includes:

• 3D printed top and bottom halves specifically for touch keying hardware.

• 3D printed port cover

• 2x M3x15mm black nylon stand offs

• 2x M3x10mm black nylon screws

• 2x M3x10mm black oxide 304 stainless screws

• 30AWG silicone jacketed wire

• K6ARK Capacitive touch board

Not included but needed:

• Trimmed legs from a resistor

Ordering options: 

Compatibility

• Fits without rails: Enclosure fits flush up against a QMX/QCX that does not have side rails.

• Fits with rails: Enclosure fits flush up against a QMX/QCX that does have side rails.

Power type

• DC barrel jack: Enclosure fits DC barrel jack power input. 

• USB-C Trigger: Enclosure fits USB-C trigger.